Associate
September 21, 2023
Question
UNICLEO-GUI
- September 21, 2023
- 0 replies
- 1449 views
Good afternoon,
I need to implement a model called "Machine Learning core" on my STM32WB board, https://www.futureelectronics.com/ftm/connectivity/future-electronics-sensor-based-machine-learning/
I created the STM32WB+X-NucleoIKS01A3 stack. I need to activate Unicleo-GUI. https://www.st.com/en/development-tools/unicleo-gui.html.I have debugged and run this Firmware (DataLog Terminal, I attach the screenshots). https://www.st.com/en/embedded-software/x-cube-mems1.html
On Unicleo-GUI I can't see the transmitted data.
Can you give me any suggestion ?
Thank you.
Best regards
Luigi Bibbo'
PS: my email is luigi.bibbo@unifi.it