I have purchased the steval-idp004v2 board. 1. How to get Example of steval-idp004v2 on STM32CubeMX? 2. From Document "AN5040",Where can I get release version "TEConcept tool" to use? 3. Reference Document "UM2232" page3.Does STM provide the project?

[Ykuo.11]

..

[Peter BENSCH]

Welcome, @Ykuo.1​, to the community!

Please note that the stack from TEConcept is not freely available and a license is required, as you can read in UM2232:

The version is fully featured but for a limited time (10000 minutes): after that, the system stops working and you

need a new free key license from TEConcept, with the hardware ID readable using their proprietary Control tool, a

graphical user interface (GUI) which enables communication with master unit and device.

Please also check the Getting Started - FAQs about IO-Link products.

If you don't want to write your own software from scratch, you should contact TEConcept as they are responsible for the IO-Link stack.

Regards

/Peter

[Ykuo.11]

Hi Peterm

If I don't have TEConcept tool , I need to use STM32CubeMX and STSW-IO-LINK(without stack) to create the Project by myself?

Or  Reference Document "UM2232" page3.

Does ST provide the project ?

Thank you.

[Peter BENSCH]

The schematics of STEVAL-IDP004V1 and STEVAL-IDP004V2 is essentially identical, so to start without stack you can try to use the project STSW-IO-LINK.

Regards

/Peter

[Ykuo.11]

I have download ​STSW-IO-LINK, but I don't know how to use STM32CubeMX to open the project.

Do you have any user manual or tutor document for STSW-IO-LINK ?

Why STM32CubeMX ST Board doesn't have the choice of STEVAL-IDP004V2?

[jgreineder]

Any update on this?