EVSPIN32F0601S3 : MotorControl Workbench 5.Y.2 ACIM

[Karan 123]

Hi,

Will it possible to run ACIM ( V/F Open/Closed Loop or FOC ) with EVSPIN32F0601S3 and Motor Control Workbench 5.Y.2  or future versions ??

--

Karan

[Laurent Ca...]

Dear @Community member​ 

Yes, it is.

Please have a look on this: best regards: https://wiki.st.com/stm32mcu/wiki/STM32MotorControl:SDK_AC_induction_motor .

Best regards

[Karan 123]

Hi @Laurent Ca...​ 

I have not seen EVSPIN32F0601S3 in this link..

--

Karan

[Jonathan Harding]

I'm also interesting in this, mainly because I can get the kit in a few days! It looks like the G431 method is a none starter at the moment as I can't get one! So is there any news on when we might be able to run an ACIM on any of the EVSPIN32F060XXXX kits?