Skip to main content
TKara.2
TKara.2
Associate III
July 15, 2024
Solved

FOC wizard: why getting this error?

  • July 15, 2024
  • 2 replies
  • 757 views

TKara2_0-1721042190028.png

why do i getting this eror

    Best answer by Gael A

    Hello TKara.2,

    Could you please send the .stwb6 of your project and tell me which version of the MCSDK you are using ?

    Also, please have a look at our ST Community guideline to ensure the best support from our part : "How to write a Motor control post to get a response quickly"

    Edit : At first glance, I can see though that your G2 gain is missing. That means that there is an undefined parameters in your Motor tab. If everything is fine there but you still experience the issue, then you can send me the .stwb6 file.

    2 replies

    Gael A
    Gael ABest answer
    ST Employee
    July 15, 2024

    Hello TKara.2,

    Could you please send the .stwb6 of your project and tell me which version of the MCSDK you are using ?

    Also, please have a look at our ST Community guideline to ensure the best support from our part : "How to write a Motor control post to get a response quickly"

    Edit : At first glance, I can see though that your G2 gain is missing. That means that there is an undefined parameters in your Motor tab. If everything is fine there but you still experience the issue, then you can send me the .stwb6 file.

    If you agree with my answer, please consider accepting it by clicking on 'Accept as solution'.Hope this will help,Gaël A.
    TKara.2
    TKara.2Author
    Associate III
    July 15, 2024

    Hello @Gael A  Thank you, this solved my problem

    Terms & ConditionsAccessibility statement