Skip to main content
SC S.1
SC S.1
Visitor II
March 13, 2023
Question

I currently done the code for bldc motor working in stm32 cube ide .I am using STM32F103C8T6. What I need to change in my code to control my motor using HAL sensors?

  • March 13, 2023
  • 1 reply
  • 1046 views

..

This topic has been closed for replies.

1 reply

Gael A
Gael A
ST Employee
September 8, 2023

Hello CS S.1,

First we would like to apologize for the delay in replying to your post.

If your point is still relevant : Hall Sensors speed sensing can be enabled via Workbench by clicking on Drive Managements, and selecting Hall Sensors in the scrolling menu, as shown in the picture :
Hall_Sensor.PNG

If you agree with my answer, please consider accepting it by clicking on 'Accept as solution'.Hope this will help,Gaël A.
Terms & ConditionsAccessibility statement