Error from BLE_SerialCom_Central

[Henry_BLE]

Hello community,

I recently tried to flash the BLE_SerialCom_Central example code onto the STM32WBA55 board. During the debug session, when I clicked the 'Suspend' button, a number of messages appeared in the debug window. I took a screenshot and attached it. I'm still struggling to find a solution to flashing the example code.
It would be great if someone who has encountered this issue before could give me some advice.
Best regards.

[Imen.D]

Hello @Henry_BLE 

I recommend you follow the configuration and guideline on this article: STM32WBA Bluetooth® LE – Serial communication - stm32mcu. As mentioned in the article, try monitoring UART debug output, this can provide further insight into any errors during flashing and debugging.

 

[Henry_BLE]

Hello @Imen.D 

I have followed the config related to UART but I still had the same trouble which I have mentioned in the screenshot. On TeraTerm there were no UART messages.