stm32wl33, IQDump

[theorvs]

I’m working with the NUCLEO-WL33CC2 development board and running ST’s CLI demonstration firmware. My goal is to retrieve raw baseband I/Q samples, but I can’t get any I/Q output using the demonstrator commands, specifically IQDump. 

If you’ve successfully extracted I/Q from this board using the stock CLI demo, I’d love to know the exact command sequence and any quirks you ran into. Suggestions welcome on required modes, baud rates, or additional steps I might be missing.

[STTwo-32]

Hello @theorvs 

Thank you so much for your help. The Register viewer feature on the STM32WL3 series is not available yet (on both GUI and CLI). I've escalated your request to be considered on the future Cube Programmer releases (under internal ticket number 218149.

Best Regards.

STTwo-32