Transmission and Receiving on LoRa E5 mini

[Sahana]

Hello everyone,
I was trying to build communication between 2 LoRa devices. Sending a "Hello" from Tx board and receiving on Rx board. I tried to debug using UART (printf through Tera Term). But I am stuck at transmitting data. Do any of you have an idea about what to do?

Thank you.

[STTwo-32]

Hello @Sahana and welcome to the ST Community.

The LoRa E5 mini is based on a STM32WL but it is manufactured by a third party. So, i suggest you have a look at this P2P example. If you still have more questions, you may contact them throw this forum.

Best Regards.

STTwo-32