lis3dsh

[Ekko Burt]

Posted on October 10, 2017 at 00:07

I am looking for the MTBF/FIT rate for LIS3DSHTR Accelerometer, with Confidence Level, Test Temperature and Activation Energy. 

Thank you.

[Miroslav BATEK]

Posted on October 10, 2017 at 06:51

Hello,

this kind of information cannot be shared over the community discussion.

Can you please send the request through the

/external-link.jspa?url=https%3A%2F%2Fmy.st.com%2Fcontent%2Fmy_st_com%2Fen%2Fsupport%2Fonline-support.html

[chaitanya chippada]

Posted on October 24, 2017 at 06:28

Hi,

      I'm using LIS3DSH accelerometer with Evaluation board STEVAL-MKI134V1 (LIS3DSH) ,with the configuration of

1600 Hz sampling frequency, 800 Hz analog filter,full scale +/- 2g,in stream mode,I'm using this sensor for collecting vibration data in my project,I'm getting 1 g in x-axis according sensor placement,but getting some offset in Y axis,like

i attached plot of vibration, I'm getting offset in Y axis below 100 Hz,Please can you tell what is the problem.

Thanks & regards,

Ch. Sai Chaitanya.