Quick Start for Unico GUI Using dFuSe Software and LSM6DSV16xx

[FKara.3]

Hello ,

I followed this tutorial for lsm6dsv16x.However, I cannot see StMicroelectronics Virtual COM Port after downloading STSW-LINK009. Besides, I could not match dfuse devices

 

 

[Federica Bossi]

Hi @FKara.3 ,

Unfortunately, that tutorial is five years old and a few things have changed in the meantime.

Now you can follow the steps reported in this user manual in section 2.2.

If this helps you, please mark my answer as "Best Answer" by clicking on the "Accept as Solution" button, this can be helpful for Community users to find this solution faster.

[FKara.3]

 

Hello @Federica Bossi ,

 

I followed the document you mentioned. However, the issue is that I don't see ST Virtual Port when I connect to my device. I upgrade the firmware through STM32CubeProgrammer. What is the reason behind this issue?