STEVAL-IDP005V1-GUI does not connect

[manikandan96]

Hi.

i am having a STEVAL-IDP005V1, STEVAL-UKI001V1, 10-pin-IDP005V1 Cable, M12female connector.

i am referring this document ( https://www.st.com/resource/en/product_presentation/steval-bfa001v1b_quick_start_guide.pdf ) 

i am not able to connect the board to my PC.  please anyone suggest me to do the analysis of accelerometer

is that any clear document? 

Thank you  

[AmrithHN]

Are you using the swd connector? 

Make sure you are powering the device 18V or higher as per the requirement

The swd connector at the steval , how did you connect to it ? whats the orientation?

[manikandan96]

Yes, i am using the SWD Connector. 
Yes, i applied the input voltage is 18.5 V. (brown Positive and blue negative)
Please refer the Picture.

 

[AmrithHN]

I don’t recall the exact orientation of the connector on the st board but you can try connecting the swd connector on stm32 in the reverse direction (I had similar issue and I figured out that the connector needs to be connected in reverse direction and then it worked)

 

Also the baud rate is mentioned in the manual make sure to set that