Skip to main content
I
ibb
Visitor II
September 3, 2004
Question

comunication with Master & Slave on ST7 and ST6

  • September 3, 2004
  • 2 replies
  • 821 views
Posted on September 03, 2004 at 05:53

comunication with Master & Slave on ST7 and ST6

    This topic has been closed for replies.

    2 replies

    I
    ibbAuthor
    Visitor II
    June 13, 2004
    Posted on June 13, 2004 at 13:04

    Hi; on any helps

    I search an assembler or ST-Realizer2 application for a ST6265 master

    and a ST72331N4 as a slave, I have load same sample (without) an

    emulator, but there is no signal.

    Have any body thes realize in actual projekt.

    The world wait for these application.

    Best Regards

    [ This message was edited by: Goliath on 14-06-2004 00:34 ]
    R
    rene2
    Visitor II
    September 3, 2004
    Posted on September 03, 2004 at 05:53

    Hi,

    Does your problem still exist?

    As a new member on this forum, it's a bit late perhaps but I'd like to point out that you perhaps did not initialize the Slave Select pin on the device.

    I know that Actum Solutions provides an application note and Realizer examples with their product. Check on www.actum.com.

    Balvie
    Terms & ConditionsAccessibility statement