Skip to main content
Visitor II
October 16, 2007
Question

St10 boot loader _ Read and write flash Procedure

  • October 16, 2007
  • 5 replies
  • 1294 views
Posted on October 16, 2007 at 06:54

St10 boot loader _ Read and write flash Procedure

    This topic has been closed for replies.

    5 replies

    newsamoAuthor
    Visitor II
    October 15, 2007
    Posted on October 15, 2007 at 11:02

    Can anyone tell me protocol to read write flash of st10f 168 or st10f275 via serial interface (asc)

    Visitor II
    October 15, 2007
    Posted on October 15, 2007 at 12:32

    Hello newsamo,

    You can use the ST10Flasher free tool provided by ST.

    It is available on the following link:

    http://www.st.com/mcu/familiesdocs-17.html

    at the bottom of the web page.

    Best regards,

    Najoua.

    newsamoAuthor
    Visitor II
    October 16, 2007
    Posted on October 16, 2007 at 06:08

    I like to write a myown tool....

    [ This message was edited by: newsamo on 16-10-2007 09:39 ]

    newsamoAuthor
    Visitor II
    October 16, 2007
    Posted on October 16, 2007 at 06:09

    Does exists protcol in document?

    [ This message was edited by: newsamo on 16-10-2007 09:40 ]

    Visitor II
    October 16, 2007
    Posted on October 16, 2007 at 06:54

    Hello newsamo,

    This can be done by using the on chip bootstrap.

    Please refer to the following discussion forum:

    http://www.st.com/mcu/forums-cat-4588-5.html

    I hope this helps you,

    Please let me know if you have further questions.

    Best regards,

    Najoua.