Skip to main content
D
dwybo
Visitor II
October 1, 2004
Question

ST10 Flasher and resetting the target

  • October 1, 2004
  • 2 replies
  • 913 views
Posted on October 01, 2004 at 13:30

ST10 Flasher and resetting the target

    This topic has been closed for replies.

    2 replies

    D
    dwyboAuthor
    Visitor II
    September 30, 2004
    Posted on September 30, 2004 at 16:12

    I am using the ST10Flasher DLL to build my own loader program for a ST10F269. Once reflashed, I would like to reset the target so the newly flashed program starts executing.

    ANyone have any ideas as to how I might be able to do that?

    Thanks
    N
    najoua
    Visitor II
    October 1, 2004
    Posted on October 01, 2004 at 06:57

    Hello,

    Before running the ST10Flasher, switch ON the bootstrap loader. Then program the flash. After the programming was successful, switch OFF the bootstrap loder and ON the single chip mode. Then, reset the controller. If every thing is working properly, your program starts executing.

    Terms & ConditionsAccessibility statement