Skip to main content
S
sadhana
Visitor II
March 29, 2004
Question

ST10F168 Boot strap mode

  • March 29, 2004
  • 2 replies
  • 757 views
Posted on March 29, 2004 at 15:37

ST10F168 Boot strap mode

    This topic has been closed for replies.

    2 replies

    S
    sadhanaAuthor
    Visitor II
    March 29, 2004
    Posted on March 29, 2004 at 10:01

    Problem statement:

    New hardware based on ST10F168, not able to go into BSL mode.

    Assumptions:

    BSL P0L.4 pin should be held at low at the power up. No other condition required on any other pins.

    Regards,

    Sadhana.

    S
    sadhanaAuthor
    Visitor II
    March 29, 2004
    Posted on March 29, 2004 at 12:57

    Can you elaborate on ''single chip mode , adapt mode and emulation Mode'' please?

    I have a target board having single ST10F168..with other peripherals connected like RTC and SRAM.

    I want to start the processor in BSL mode so that I can download the required program for peripheral testing.

    At present, I'm using ST10Flasher utility and it gives me the error saying BSL Acknowledgement not received.

    My suspicion is my processor is not getting either proper reset requence or may be not going to BSL mode for some reason. I am in a process of finding out the cause.
    Terms & ConditionsAccessibility statement