STEVAL-DPSTPFC1

[bobjeng]

hi,

I start to use STM mcu to develop power electronic circuit and software , I find the following stuff " STEVAL-DPSTPFC1 3.6 kW PFC totem pole with inrush ......."   is the best reference design to me for learning ,  would you please deliver its schematic and source codes to me for study  ?  

as early as possible.

thank you.

Bob

[Peter BENSCH]

Welcome @bobjeng, to the community!

For security reasons, only the binary file is provided for such high-power applications, not the source code.

You are welcome to get in touch with your local distributor or sales contact who will help you realise your project if the quantity is large enough.

Good luck!

Regards
/Peter

[bobjeng]

hi Peter,

thank you for reply. 

the purpose that I want to have sources of the mentioned reference design is for :

1.  I change to use STM32f334r8 MCU to design the required boost circuit in power system.  But I am not quite familiar in designing software switching by connections among peripheral units of MCU and the SiC Mosfet units.

2,  I want to know how software programming about configuration, initialization,  NVIC, perform operations of ADC, DAC, Timers, COMPs, GPIO, ....etc. 

3.   I think to refer to source codes will be very helpful and speed my understanding to use STMelect solutions.  I hope you fully understand.

 

thank you.

Bob

[Peter BENSCH]

I fully understand. But to make sure you understand everything as well, here are the details again:

For security reasons, no source code is provided for high-power boards such as this one. The community cannot help you, but the distributor in your region may be able to.

Regards
/Peter