TMC5160 Plus and the STM32F446RE Nucelo

[idris_00711]

Hi,

     Does anyone have any experience or knowledge on how to successfully connect the TMC5160 Plus (BigTreeTech) stepper motor driver board and an STM32 ( I have the Nucelo F446RE)? I have tried SPI but can't get a clear signal back.

[KDJEM.1]

Hello @idris_00711 and welcome to the community,

 

I recommend you to look at this post may help you.

 

Thank you

Kaouthar

[Andrew Neil]

---

@idris_00711 wrote:

TMC5160 Plus (BigTreeTech) stepper motor driver board .

---

You mean this: https://global.bttwiki.com/TMC5160TPlus.html#marlin-firmware-settings ?

Have you contacted BigTree for support: https://support.biqu3d.com/hc/en-us ?

https://community.biqu3d.com/

 

---

@idris_00711 wrote:

I have tried SPI but can't get a clear signal back.

---

What, exactly, have you tried?

How to write your question to maximize your chances to find a solution

 

Do you have a clear definition of the TMC5160's SPI mode and its requirements ?

Have you used an oscilloscope and/or logic analyser to confirm that you are meeting those requirements ?

 

PS:

User Manual is here (via this link on the above Wiki page); it says:

If you need further resources for this product, you can find them at https://github.com/bigtreetech/

If you cannot find what you need, you may contact our after-sales support [e-mail]