Does it support ST-LINK V1?

[Ruslan1]

I'm trying to debug my stm32vldiscovery. The error "ST-LINK V1 not supported" appears. Does it mean that stm32CubeIDE doesn't support it? I haven't seen that in release limitations.

[JKAKK]

I am also facing the same issue. Hope the CubeIDE doesnt support ST-Link V1

[Tesla DeLorean]

Your wish is likely true. It is a deprecated version.​

[Georgy Moshkin]

You can still perform "flash and run without debug" with st-link v1 in CubeIDE using ST-LINK_CLI.exe utility, check this thread:

https://community.st.com/s/question/0D53W00000DGpMn/i-cant-use-the-stlink-in-stm32cubeide-even-after-updating-the-stlink-firmware