No St Link Detected

[JElph]

Hi Everyone,

I have a STM32F407 MCU development board (STM32F407VET6).

The ST-Link Utility keeps displaying "No ST-LINK detected" - how do I overcome this?

The development board I purchased: https://www.ebay.com.au/i/302449171492?chn=ps

Any help would be greatly appreciated.

Kind Regards

Jordan

[S.Ma]

This board does not include on-board ST Link, the JTAG 20 pin connector is on the board edge.

The USB is for the target user MCU if programmed with USB example.

Cheaper by cutting limbs?

[Tesla DeLorean]

Do you have an ST-LINK device?

Perhaps if you jumper BOOT0 HIGH you can connect device via USB in DFU mode and use the STM32 Cube Programmer application in USB mode, not ST-LINK mode.​