No Target Device found.

[patliputram]

Dear ST community member,

I am new to ST platform.

I am using STM32G030C8T6 Development board from 7 Semi and ST Link V2.

Dev board link: https://evelta.com/7semi-stm32g030c8t6-arm-stm32-mini-development-board/?srsltid=AfmBOorI6XBlJ_AMXNVV184OhO-lB02AFODj1611j8H62qR2M0FZkmF9

Connection: 

• dev board USB: power
• dev board RST: NSRT or pin15 of ST LINK V2
• dev board SWDIO: pin 7 of ST LINK V2
• dev board GND: pin8 of ST LINK V2
• dev board SWDCLK: pin9 of ST LINK V2
• dev board 3.3: Not connected

 

Please guide me where I am doing wrong.

 

Thanks in advance

Regards,

Anand Sagar

 

 

[MM..1]

STLinkV2 exist in ISOL variant , then 3.3V require to connect...

Next issue maybe is DFU bootloader try change reset behaviour to connect under reset

[patliputram]

I am using ST LInk V2, not IOSL, and providing power suing type C USB connector. 

also validated the pins connection, all are fine.

 

[AScha.3]

Hi,

>using ST LInk V2

Which one : like a stick , or original , like small box ? (original: need connect 3v3 )

+

Use CubeProgrammer , connect (set: software reset), show pic, what its telling.