Nucleo User Manuals don't show the VCP UART connection

[Andrew Neil]

eg, UM2179 STM32 Nucleo-144 boards (MB1312):

Related:

https://community.st.com/t5/stm32-mcus-products/printf-causes-terminal-to-stay-just-empty/m-p/644954/highlight/true#M236811

@mƎALLEm 

 

[Andrew Neil]

Also UM1724 for the Nucleo-64s:

 

 

[Andrew Neil]

UM1956 (Nucleo-32) just doesn't label the connection at all:

 

[mƎALLEm]

Reported also for UM1956 and UM1724 

[Andrew Neil]

Probably also worth a general check on Discovery and other boards ...

[Andrew Neil]

But UM1974 for Nucleo-144 boards (MB1137) does show it!

 

 

[mƎALLEm]

An internal Ticket 174798 has been raised to fix the issue.
Thank you @Andrew Neil  for raising this.

[Andrew Neil]

---

@mƎALLEm wrote:

An internal Ticket 174798 has been raised to fix the issue.
Thank you @Andrew Neil  for raising this.

---

@mƎALLEm Any update on this?

The manuals have not been corrected yet, and this continues to cause confusion:

https://community.st.com/t5/stm32-mcus-products/communication-between-nucleo-f411re-and-raspberry-pi-using-st/m-p/721545/highlight/true#M261177

 

[mƎALLEm]

@Andrew Neil 

Unfortunately not yet and I don't have a visibility on this fix.

The only info is just this will be applied to the new Boards' UMs. For the old ones I cannot confirm.

[Andrew Neil]

Another one - F429-DISCO:

https://community.st.com/t5/stm32-mcus-products/problems-with-data-reception-via-usart3-on-stm32f429-disco-board/m-p/741827#M265971

[mƎALLEm]

It was escalated but unfortunately I cannot commit on the modifications.