ST-link V2 not working with STM32Cube Programmer V 2.8.0

[KJagt.1]

HI Everyone

I have ST-LINK/V2 . its working with STM32 ST-LINK Utility V4.6.0

But whenever I using ST-LINK/V2 with STM32Cube Programmer V 2.8.0. ST-LINK/V2 not detect and not able to download program Even STM32cube Programmer can't recognized either ST-LINK/V2 connected or not.

#STM32CubeProgrammer​ 

#ST-LINK

Please Help Me

[Peter BENSCH]

Welcome, @KJagt.1​, to the community!

Could you please add a photo of your ST-LINK/V2 here, preferably with front and back?

Regards

/Peter

[KJagt.1]

[Peter BENSCH]

Thank you, they look ok.

Can you please upgrade your STM32CubeProgrammer to the latest version and check again?

Regards

/Peter

[Tesla DeLorean]

That's a very old version of STM32 Cube Programmer

You might also need contemporary firmware in the ST-LINK to operate properly with specific applications and versions thereof.​

[Mike_ST]

Hello,

From pictures, and because they are not working, there is a high chance those are clones.

[KJagt.1]

Could you please share athourized ST supplier list in India, it will helpful to me

Thank you

[Peter BENSCH]

You can find official distributors at this link, where you select Distributors under By Contact Type and your region, i.e. India, under By Country/Region.

Good luck!

/Peter

[AScha.3]

>But i orded 3. 2 out of 3 working fine with stm32cube Programmer

so just one is defective. buy a new, or give back for exchange.

 

or open the not working one and : it look like this original ?

show a good pic - if possible.

[Peter BENSCH]

Update: meanwhile there is a knowledbase article on the topic: How to recognize a genuine ST-Link/V2 versus a cloned one?, created by Amel NASRI.

Regards

/Peter