Skip to main content
F
FarukSozuer
Visitor II
June 16, 2020
Solved

STLINK V3 CubeIDE

  • June 16, 2020
  • 1 reply
  • 770 views

Hello;

Can anyone run STLINK V3 with CubeIDE? I can delete and load the hex code inside the processor using STLINK_Cube Programmer.But when I try to enter debug through CubeIDE, I get the following error. Anyone who has encountered this error and can find a solution?0693W000001qqc5QAA.png

Sincelery

    This topic has been closed for replies.
    Best answer by FarukSozuer

    Thank you for answer. I solved the problem. I guess you shouldn't leave the frequency setting on auto. I do not know if it is a special case for the processor series I use. I had to set the frequency setting to 8000 for the F1 family.

    1 reply

    T
    TDK
    Super User
    June 17, 2020

    Works for me. Make sure it's not open in another application. Using a BluePill? Wouldn't be surprised if that was the source of the problem.

    F
    FarukSozuerAuthorAnswer
    Visitor II
    June 17, 2020

    Thank you for answer. I solved the problem. I guess you shouldn't leave the frequency setting on auto. I do not know if it is a special case for the processor series I use. I had to set the frequency setting to 8000 for the F1 family.

    Terms & ConditionsAccessibility statement