STM32H7S78-DK/MH1736 cannot detect st-link

[Gaobo]

 

I downloaded the boot code generated by following the settings in Figure 3 (the frequency configuration to 600Mhz) into the flash of the 0x08000000 starting address, and then the stlink cannot detect after re-powering (as shown in Figure 1). But my device manager can detect the device (as shown in Figure 2).

Can someone help me with that? Thank you very much!

 

 

figure1

 

figure2

 

figure3

 

[KDJEM.1]

Hello @Gaobo and welcome to the community;

 

Could you please

• Try to upgrade Firmware using STM32CubeProgrammer and erase external memory.
• Refer and follow the steps shared in this FAQ: How can I recover my STM32H7 board after facing a power configuration deadlock?

I hope this help you!

Please let me know if the issue is solved or not?

 

Thank you.

Kaouthar

 

 

 

 

[Gaobo]

Thank you very much!