Zephyr RTOS on Nucleo-F411RE ?

[Kumar123]

Hi 

Is it possible to run Zephyr RTOS on the STM32F411RET6 Nucleo board? If it is possible, how can I set up and use Zephyr RTOS on it? Please suggest the steps.

[T_Hamdi]

hello @Kumar123 

Yes, it is possible to run Zephyr RTOS on the STM32F411RET6 Nucleo board. For detailed information on board specifications, supported features, and configuration, you can refer to the official Zephyr documentation here:
Zephyr Board: Nucleo F411RE.

also to get started with Zephyr RTOS on the STM32F411RET6 nucleo board, you can follow the official Getting Started Guide provided by the Zephyr Project:
Getting Started Guide — Zephyr Project Documentation.

 

 

[Kumar123]

Hi T_Hamdi

Thank you for your response.

I have installed the Zephyr IDE and used the Blinky LED example. The firmware was flashed successfully; however, the LED is not glowing.

I have attached an image for your reference. Please take a look.

[Andrew Neil]

Follow-on question: Zephyr Blinky LED example not blinking.

 

@Kumar123 - please keep to one question per thread.

---

Edited to correct link.

[Kumar123]

Hi Andrew Neil

The above link are not open.