Skip to main content
O
OGavr.2
Visitor II
July 15, 2020
Question

What programmer I can use for program and debug STM32MP1?

  • July 15, 2020
  • 2 replies
  • 1135 views

Can I use ST-LINK/V2 for debug and program STM32MP1 chip series?

    This topic has been closed for replies.

    2 replies

    A
    ArmandG
    ST Employee
    July 16, 2020

    Hi @Community member​ ,

    I advise you to use our software STM32CubeIDE which perfectly suits for STM32 products.

    By the way Keil and Mbed can be used as well.

    Regards,

    Armand

    P
    PatrickF
    Technical Moderator
    July 16, 2020

    Either STLINK-V2 or STLINK-V3 could be used to debug STM32MP1 series (STLINK-V3 will bring an UART Virtual Comm Port if suitable connector such as STDC14 is present on your own board).

    STLINK-V2 embedded is on EV1, DK1/DK2 boards ('embedded' version bring VCP).

    Platform debug usually also requires an UART console connection (such as VCP) and Ethernet (or Ethernet over USB).

    Note that in opposition to STM32 MCUs, the platform flash programming of STM32 MPUs are NOT done using ST-LINK, but rather use directly USB (still using STM32CubeProg).

    See https://wiki.st.com/stm32mpu

    Terms & ConditionsAccessibility statement