Header files not found by VSC

[Jacek3]

I have problem that most headers are not visible so a lot of dependent problems occured.

All files are present - the same project compoiled in STM32CubeIDE works.

There is note that "clang(pp_file_not_found)"

Tried to add paths in CMakeLists.txt but no luck.

[Cartu38 OpenDev]

@Jacek3 have you a .clangd file added by STM32Cube to your project root ?

If not maybe look at https://community.st.com/t5/stm32cube-for-visual-studio-code/after-installing-stm32cube-for-visual-studio-code-why-do-two/td-p/839930 ... not code indexing related by explain a bit proper process to end up good setup.

[Jacek3]

@Cartu38 OpenDev Thank You for response.

Yes, I have .clangd file, but it was created rather by VSC, not STM32Cube.

My .clangd file:

CompileFlags:
 Add:
 - '-ferror-limit=0'
 - '-Wno-implicit-int'
 CompilationDatabase: build/release/build
Diagnostics:
 Suppress:
 - unused-includes
 - unknown_typename
 - unknown_typename_suggest
 - typename_requires_specqual

 

I have in Output window:

[driver] NOTE: You are configuring with preset release, but there are some overrides being applied from your VS Code settings.

and

can't open .map file

 

I suppose that the reason is that STM32Cube use .../Release or .../Debug while compile but VSC use .../buil/release or .../built/debug. 

Do You know how can i change it in VSC?

[Cartu38 OpenDev]

@Jacek3 

 

[manny_akimbo_CandCpp]

I don't think the debug and release thing is the issue, I'm on Debug and have the same issue, and to change it just go to Command Palette: (Ctrl:Shift:P) and then type CMake: Select Configure Preset and select that