Solved
is there a way to use the STM32CubeMonitor-Power in a headless mode directly from cli? or any ideas to automate power measurement acquisitions using the X-NUCLEO-LPM01A board
..
This topic has been closed for replies.
Hi,
The User manual UM2269 (um2269-getting-started-with-powershield-firmware-stmicroelectronics.pdf) describes the CLI available with the Powershield. CLI will allow you to command the powershield with an hyperterminal.
Regards
Philippe
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.