IOC configuration for digital signals to go low

[Sushmita]

Please find the given DSO image !!!! blue is fault signal and yellow is PWM 

 I need to stop the PWM, if a fault will come, while doing this my PWM is  turning off  but not fully its showing a ramp down of 88usec and then becoming zero.

 given configuration in my IOC

GPIO setting for timer  and fault signal is 

 GPIO mode: Alternating PUSH PULL 

   pull down 

 

 

[Richard.Chvr]

Hello @Sushmita 

 

I'm not sure to understand your problem, What STM32 Cube Monitor tool are you using?