I can't connect to STM32F103C8T6 using STM32CubeProgrammer

Forum|Forum|2 years ago
April 11, 2024
2 replies
2316 views

I tried to connect but it's always: "No STM32 target found! If your product embeds Debug Authentication, please perform a discovery using Debug Authentication"

I also try "Under reset" mode but still not working.

Can someone help me

Error

This topic has been closed for replies.

Best answer by mƎALLEm

Hello,

Sorry this is neither ST’s board (blue pill most probably with a contrefit chip) nor an ST’s ST-link (copied ST-Link), I cannot help you.

mƎALLEm

Technical Moderator

Hello,

Are using a USB data cable or charging cable?

"To give better visibility on the answered topics, please click on ""Accept as Solution"" on the reply which solved your issue or answered your question."

C

chin-suAuthor

Associate

I used USB data cable

mƎALLEm

Technical Moderator

What is the board are you using? ST board? Custom board?
Check the power supply of the MCU.
ST-Link firmware updated?

"To give better visibility on the answered topics, please click on ""Accept as Solution"" on the reply which solved your issue or answered your question."

Tesla DeLorean

Guru

Show a schematic

Error suggests chipsnis not powered or connected correctly.

Make sure the ST-LINK gets the VTarget power from the board.

Tips, Buy me a coffee, or three.. PayPal VenmoUp vote any posts that you find helpful, it shows what's working..

C

chin-suAuthor

Associate

I think i connected correct

Sign up

Login with SSO

Login to the community

Login with SSO

Scanning file for viruses.

This file cannot be downloaded