Are there any CAN Open and CAN J1939 protocol stack available for STM8 MCUs?

[H_H_11]

Hi,

We have a requirement of support for CAN Open and CAN J1939 on STM8AF5288T.

We found a website: Simma Software which provides this support but we want to confirm if STM officially supports their CAN Open and CAN J1939 stacks for STM8.

Kindly let us know if there are any other officially supported stacks and guide us through the same.

Thanks.

[Peter BENSCH]

Welcome, @H_H_11​, to the community!

These are examples of software that is not offered by ST, but by partners. The list would become too long to include here, but you can find suitable partners and solutions on our Embedded Software site.

At the opportunity: please consider that all STM8A have been set to NRND and can only be delivered until 2031.

Regards

/Peter

[H_H_11]

Thanks @Peter BENSCH​ for quick response!

Will consider the STM8A situation as you mentioned.

Regards,

Hrithik

[Peter BENSCH]

Great and good luck!

If the problem is resolved, please mark this topic as answered by selecting Select as best. This will help other users find that answer faster.

/Peter