stm8s105k6c6

[mbr972]

 

Hello, 

I'm looking to read and write on an stm8s105K6c6 of a hoover, and would like any information that would enable me to carry out these tasks (chip and st-link v2 wiring diagrams), as well as the most appropriate software...

Thank you

*This post has been translated from French to comply with the ST Community guidelines.

[Peter BENSCH]

Welcome @mbr972, to the community!

I would be very surprised if the manufacturer of the hoover had not protected the IP of the STM8 with the ROP function (see data sheet, section 4.4). I am therefore not holding out any hope that you will be able to realise your project successfully.

Regards
/Peter

[mbr972]

Merci, je suis novice en la matière. Et veux tenter l'expérience, j'ai acheté une stm8s105k6t6, mais je ne sais pas les correspondances entre le st-link et la puce, du moins pas de certitude. 

RST= NRST pin 1

SWIN= PD1 SWIN pin 42

SWCLK= PD0 pin 41

SWDIO= VDDIO_1 pin 8

3.3v = VDD pin 7

GND= VDDA pin 13

Merci cordialement