STM32-NUCLEO-F411RE using two I2S result in loop in I2S_WaitFlagStateUntilTimeout() Hi, it's my first time using a STM32-NUCLEO-F411RE (actually the STM32 in general) and im trying to get some audio using a i2s MEMS microphone, modifying it using the DSP, and outputting it on another i2s.The microphone is working, and im turning a led on and off whenever it reads an amount of sounds over a threshold, dps is working fine aswell, however, when i turn the other i2s on (deactivating the SPI on the Cube IDE and activating the other i2s) the microphone is going in a loop as soon as i use HAL_I2S_Receive, going in a loop on : static HAL_StatusTypeDef I2S_WaitFlagStateUntilTimeout(I2S_HandleTypeDef *hi2s, uint32_t Flag, FlagStatus State,
uint32_t Timeout)
{
uint32_t tickstart;
/* Get tick */
tickstart = HAL_GetTick();
/* Wait until flag is set to status*/
while (((__HAL_I2S_GET_FLAG(hi2s, Flag)) ? SET : RESET) != State)
{
if (Timeout != HAL_MAX_DELAY)
{
if (((HAL_GetTick() - tickstart) >= Timeout) || (Timeout == 0U))
{
/* Set the I2
