SPC5 studio user manual

[Saravanan_Mari]

Hi everyone,

we are working on BLDC motor driver development for E-cycle and E-bike for that we choosen a controller SPC560P controller in that are going to use FOc algorithm and our application for that we want to generate some basic peripherals using the SPC5 studio for that I cannot find any user manual please share any user manual for SPC5 studio IDE

Due to this our activity is delaying for this Environment setup because there is no proper documentation then if learn by trail and error means it takes time so please any one help on this regard

[Giuseppe DI-GIORE]

Hello,

Please have a look at AutoDevKit tutorials with dedicated part for SPC5Studio:

Part #1: https://www.youtube.com/watch?v=WDp4XmmwEwc

Part #2: https://www.youtube.com/watch?v=pQeyJQBHV1c

Part #3: https://www.youtube.com/watch?v=3iCMWjYalwg

Part #4: https://www.youtube.com/watch?v=3iCMWjYalwg​ 

Ignore AutoDevKit part if not needed.

Regards,

Giuseppe

[Saravanan_Mari]

We already seen this but it is not supported for SPC560P line so Please give a general User manual for the SPCstudio and explaining to create a new project with step by step document

Thanks in advance

[Msert.1]

Hello,

I advise that learning by trial and error because I experienced same thing. There is no other document except a few youtube video links about how to use. Finally, watch the video carefully, save the changes step by step after doing change and click the generate button for seeing the changes.

Best Regards,

[Saravanan_Mari]

Could you please share video links,

and we bought the SPC560p - DISP board but in that we cannot able to flash the code using the USB cable

If we need to do some Debug configuration in the tab beacause we getting a error as (refer the Picture)