Hello, I am currently performing GNSS simlation with TeseoAPP EVK(hardware type:Teseo 5).I am changing the power offset of one of the the satellite in simulation environment. In which RTCM message i can see changed power offset from Teseo suite proa

[kmahe.1]

Test environment : GNSS simulation

GNSS simulator : Rohde and schwarz vector signal generator

Receiver : TeseoAPP EVK(hardware type : Teseo 5)

[Tesla DeLorean]

What's the question?

You should be able to Edit your own posts, see V icon in upper right of posting.

RTCM3 MSM messages presumably would reflect CNO on L1, L2, etc bands for each satellite for which observation data is reported.

Seems similar or duplicative https://community.st.com/s/question/0D53W00001rtxmnSAA/helloi-am-sending-a-test-messagetest-to-the-teseoapp-evkhardware-type-teseo-5but-i-dont-get-a-response-messageresp-backis-there-any-rtcm-message-where-i-can-decode-to-check-the-status-of-my-test-message-sent