BlueNrg2M2sp Invalid HCI Command

[MCV.1]

Hi i am using Bluenrg 2 m2sp as network processor mode , Here when i sent aci_gatt_update_char_value_ext command , some times i getting getting invalid command response . may know the reason , if i get invalid response , shall i retry same command once .

Regrds

Manukumar

[Winfred LU]

I think those might be Invalid HCI Command Parameters (code 0x12).

Please check the differences between successful and failing commands. Possibly some parameters were incorrectly configured for the failing cases.

[MCV.1]

Thanks Winifred your response , i will check which command parameter are incorrect during the response