I want use L6201PS.It has a heat pad under the chip. Should I connect the Heat pad to the GND? Or just leave it ?

..

This topic has been closed for replies.

Best answer by Cristiana SCARAMEL

Hello @�?��? 岩原 and welcome to the ST Community.

The slug (heat pad) is internally connected to the pins 1,10,11 and 20 (GND pins).

You can solder the slug on the PCB to improve power dissipation maximizing the ground layer.

Let me know if I addressed your concerns, if so please "Select as Best" label

Technical Moderator

Hello @�?��? 岩原 and welcome to the ST Community.

The slug (heat pad) is internally connected to the pins 1,10,11 and 20 (GND pins).

You can solder the slug on the PCB to improve power dissipation maximizing the ground layer.

Let me know if I addressed your concerns, if so please "Select as Best" label

"If you feel a post has answered your question, please click ""Accept as Solution"""

Associate

I understand.

Thank you very much.

Sign up