Hi,
I would like to use the evaluation board STEVAL-IME014V1B to drive piezoelectric transducers for medical applications. Does the evaluation module include a built-in H-bridge for direct drive of ultrasound transducers? May I directly connect the demo board to the transducers?
Regards
Welcome
The STEVAL-IME014V1B is based on the STHV1600, which can directly drive 16 transducers.
However, no one here in the community can support either of these options because information about STHV1600 is only available under NDA from your local distributor or ST office.
Hope that helps?
Regards
/Peter
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.