6 step algorithm in Steval-spin3202 with A2212 13T 1000 kV motor

[sambit_das]

Currently I am implementing a 6 step algorithm in Steval-spin3202 with A2212 13T 1000 kV motor. While starting the motor with motor pilot I am getting an overcurrent fault. Please give me suggestion how to overcome this error.  

[Fabrice LOUBEYRE]

Hi, first i suggest you have a look on the ST wiki web site the following document:
STM32MotorControl:6-step - Optimization and troubleshooting of sensor-less firmware parameters - stm32mcu

You will find pieces of information to tune the start-up phase that can create the overcurrent.

Hope this will help you.

Fabrice