Skip to main content
H
hashiR
Associate III
September 11, 2024
Question

Errors in stmcubeide when generating motor profiler code with MC Workbench 6.3.0

  • September 11, 2024
  • 3 replies
  • 770 views

hello community,

issue : Error in stmcubeide when generating motor profiler code with MC Workbench 6.3.0 

what will be the reason ?

 

 

 

hashiR_0-1726039623773.png

3 replies

GMA
GMA
Technical Moderator
September 11, 2024

Hello @hashiR and welcome to ST community,

Could please add more detail about your use case as described in this post?

If you agree with the answer, please accept it by clicking on 'Accept as solution'.Best regards.GMA
    H
    hashiRAuthor
    Associate III
    September 18, 2024

    When I check the 'Motor Profiler' box in Motor Control Workbench (v6.3.0) and generate the code, errors appear in STM32CubeIDE (v1.16.0). However, when the 'Motor Profiler' box is unchecked, everything works fine.

    hashiR_0-1726638012551.png

     

    Andrew Neil
    Andrew Neil
    Super User
    September 11, 2024
    @hashiR wrote:

    what will be the reason ?

    Exactly as it says: you have not defined those symbols - therefore, they are undefined.

    Have you omitted the file(s) which would define them?

     

    A complex system that works is invariably found to have evolved from a simple system that worked.A complex system designed from scratch never works and cannot be patched up to make it work.
    GMA
    GMA
    Technical Moderator
    September 18, 2024

    Hello @hashiR,

    What is the used ST platform?

    If you agree with the answer, please accept it by clicking on 'Accept as solution'.Best regards.GMA
    Terms & ConditionsAccessibility statement