Skip to main content
T
tejas_amp
Associate III
November 23, 2024
Question

OCP in STEVAL-ESC001V1 not supported in MC Workbench

  • November 23, 2024
  • 1 reply
  • 477 views

OCP in STEVAL-ESC001V1 is mentioned in its user manual, but in MC Workbench while generating project, neither OCP nor Driver Protection support is present. Please clarify?

1 reply

GMA
GMA
Technical Moderator
November 25, 2024

Hello @tejas_amp,

This issue has been already reported, please check following post.

If you agree with the answer, please accept it by clicking on 'Accept as solution'.Best regards.GMA
Terms & ConditionsAccessibility statement