STEVAl-CTM006V1 motor profiling.

Hi,

please advice with the issue of motor profiling.

mcsdk: 6.2.1

control board: nucleo-g474re

Bridge: XNUCLEO-IHM09M2

Power Board: STEVAL-CTM009V1

Motor: Motenergy ME1304

How can I run motor profiler for this setup?

MC Workbench does not allow to generate FW for motor profiler.

Best regards, Taras.

This topic has been closed for replies.

Best answer by cedric H

Hello @tasifacij ,

Unfortunately, the profiler FW supports only 3-shunt topology. It is why MC Workbench prevents you to generate your project.

The best advice I can give you is to enter your motor characteristics manually following this user guide :

Regards

Cedric

cedric HBest answer

Technical Moderator

Hello @tasifacij ,

Unfortunately, the profiler FW supports only 3-shunt topology. It is why MC Workbench prevents you to generate your project.

The best advice I can give you is to enter your motor characteristics manually following this user guide :

Regards

Cedric

Associate II

Appreciate

Sign up