STEVAL-ESC002V1 with NUCLEO-F031K6 board

[gndLD]

Hello. I have been researching how to use the STEVAL-ESC002V1 with a NUCLEO-F031K6 board to run a BLDC motor. The documentation mentions using the IAR Embedded Workbench for ARM 8.22, but I am programming with the STMCubeIDE and the MotorControl Workbench 6.3.2. Could someone help direct me on how to do this?

[gndLD]

I am currently looking through the Inverter tab after starting a new project in MotorControl Workbench 6.3.2, and I do not see the STEVAL-ESC002V1 listed. Will this be supported?

[gndLD]

I have been following this thread and wondering if there has been any solution.

[STuser2]

I have not used this board but verify if you can use the MCSDK Board Designer software to design this board and generate code.  

[gndLD]

Are you referring to this? https://www.st.com/en/embedded-software/x-cube-mcsdk.html 

[gndLD]

BTW there are associated software files provided with STSW-ESC002V1 when I look it up online. I just don't know if I can use those files in my STM32CubeIDE firmware.