Skip to main content
Z
Z-YF
Associate III
April 25, 2025
Solved

Some problems in using CubeMX to modify CSI

  • April 25, 2025
  • 1 reply
  • 580 views

I met a problem when using CubeMX to modify the CSI to start the camera module, but it shows that the CSI cannot be adjusted correctly. I want to know how to solve this problem.

Best answer by Souhaib MAZHOUD

Hello @Z-YF 

Since Version 6.14.1 of CubeMX, you can only activate CSI mode by setting the CSI peripheral. However, to configure the parameters of CSI, go to Serial Interface Configuration under DCMIPP.

BR,

Souhaib

1 reply

S
Souhaib MAZHOUD
Technical Moderator
April 25, 2025

Hello @Z-YF 

Are you using STM32CubeMX V6.14.1 ?

 

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.
Z
Z-YFAuthor
Associate III
April 25, 2025

Yes.

S
Souhaib MAZHOUDBest answer
Technical Moderator
April 25, 2025

Hello @Z-YF 

Since Version 6.14.1 of CubeMX, you can only activate CSI mode by setting the CSI peripheral. However, to configure the parameters of CSI, go to Serial Interface Configuration under DCMIPP.

BR,

Souhaib

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.
Terms & ConditionsAccessibility statement