Nucleo-144 F722ZE, Arduino, no blink no Serial.print() output Hi,I have a Nucleo-144 F722ZEI am attempting to program it with the arduino 2.3.2 ide.And so far, no blink, no digitalWrite() and no Serial.println()Details are listed below.Thank you in advance. I am sure it is trivial, and apologize for having to ask. I have not found any document that helps me solve the problem. For setup, I followed the instructions here, https://community.st.com/t5/stm32-mcus/how-to-program-and-debug-the-stm32-using-the-arduino-ide/ta-p/608514 Here is the blink code. This does blink anything and does not produce any output on the Serial Monitor in the Arduino IDE void setup() {
// initialize digital pin LED_BUILTIN as an output.
pinMode(LED_BUILTIN, OUTPUT);
Serial.begin(9600);
while( !Serial);
}
// the loop function runs over and over again forever
void loop() {
Serial.println("here i am");
digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for
