Change board selection after code generation

[pass3master]

This is a question about STM32CubeIDE.
When creating a new STM32 project, you select the board, but is it possible to select the board again after customizing the auto-generated code for us?

[STTwo-32]

Hello @pass3master 

---

@pass3master wrote:

When creating a new STM32 project, you select the board, but is it possible to select the board again after customizing the auto-generated code for us?

---

No.

Best Regards.

STTwo-32

[pass3master]

Thank you for your response. Your quick response was very helpful.