Skip to main content
Ezgi
Ezgi
Associate III
May 25, 2021
Question

connect the cube programmer

  • May 25, 2021
  • 2 replies
  • 640 views

Hi,

I'm programming my custom board using j-link. I want to use cube programmer but I can't connect. What should I do?

This topic has been closed for replies.

2 replies

TDK
TDK
Super User
May 25, 2021

Verify your schematic. Ensure power rails are good. Verify chip orientation. Use a different cable. Use a different board. Reboot. Post the actual error.

"If you feel a post has answered your question, please click ""Accept as Solution""."
Tesla DeLorean
Tesla DeLorean
Guru
May 25, 2021

Cube Programmer is for ST-LINK, not Segger J-Link.

Use appropriate tools.

Tips, Buy me a coffee, or three.. PayPal VenmoUp vote any posts that you find helpful, it shows what's working..
Ezgi
EzgiAuthor
Associate III
May 25, 2021

I want to read data from my external flash. So that I was writing an external loader for cube programmer. If then, what should I do? Could you suggest anything?

Terms & ConditionsAccessibility statement