I'm using the NUCELO-L152 and I want to sept the WRP bits with the cube programmer. When I set a bit and click on apply, I get the error message: "option Byte WRP does not exist". What is the process to set the WRP bits with the cube programmer?

[JMene.1]

..

[TDK]

You might try the command line version instead. Perhaps it is named WRP1 and not WRP.

[Houda GHABRI]

Hi @JMene.1​ ,

I confirm there is an issue when configuring WRP option Byte for L152 family.

I will submit an internal ticket to CubeProgrammer development team but I need to be sure about this two points :

• Are you using STM32CubeProgrammer 2.8.0 version?
• Arre you using ST-Link connection?

Thanks for bringing this error to our attention.

Houda

[JMene.1]

Thanks Houda. The answer is yes to both questions.

[Houda GHABRI]

Hi @JMene.1​ ,

Thanks for your feedback.

I submit an internal ticket to CubeProgrammer development team to debug further and fix the issue.

Houda