STM32F030F4P6 programming

[NİHAT_EEE]

Hi, I have a problem about upload program. I make size photocell with STM32F030F4P6 MCU. After I set hardware and software, I can not upload programming to MCU. I try to upload programming with ST-LİNK V2. And writing problem at console. Error is that ;

Target no device found

Error in initializing ST-LINK device.
Reason: No device found on target.

What can I do?I control connection pinout. Coming 3.3V and connection pinouts is correct. Please Can you give advice?

Thank you.

[Peter BENSCH]

Welcome @NİHAT_EEE, to the community!

Is your ST-LINK/V2 in a colourful metal box?

Regards
/Peter

[NİHAT_EEE]

Yes, it is colourful metal box.

[AScha.3]

do you have any other STM board or discovery board , to test : connect and working with CubeProgrammer ?

 

[NİHAT_EEE]

Yes, I try cube programmer and ST-link V2 at breadboard. İt is working both of them.

[AScha.3]

so on your breadboard its ok, you can program the cpu ?

then you have some bad or wrong connection to your target board. 

boot0 low ?

connect mode : " software reset "

 

[EmiloEmilo]

Niekedy je potrebné pripojiť aj NRST programator s doskou.