Debugger misses start of the program in STM32CubeIDE When debugging my firmware using STM32CubeIDE, the debugger seems to miss the start of the program. As an example, when I put breakpoints right at the top of main(), they are ignored. It's not only a couple of lines that are affected, but pretty much all the initialization etc. cannot be debugged because breakpoints there do not have an effect.It seems to me as if the program would start before the debugger is ready/active, therefore debugging is only possible with a delay.To confirm this, I put the following code at the top of main:int test = 1;
while(test)
{
}The while-loop is not left until I manually change the value of test to 0, which then makes it possible to set breakpoints to other lines following, where breakpoints were ignored before.This is very frustrating, as it makes debugging very cumbersome.Also, if I add a specific call to my main() (HAL_DMA_DeInit()), I get the following error, which also seems to be related to gdb...?Open On-Chip Debugger 0.12.0-rc1+dev-00061-g5e9b
